Previous: Satellite Imagery - Listing Image Data Next: Satellite Imagery - Copying and Displaying Images Table of contents Index Glossary Images Frames ITC-NGIC McIDAS-X Training Workshop > Imagery Display and Analysis > Satellite Imagery

5.0.4 Satellite Imagery - Changing the Image Resolution
In this exercise, you will magnify the resolution of displayed images using the IMGDISP command. Then, you will use the IMGPROBE command to list data values inside the cursor. Many other commands, for example IMGCOPY, have parameters to change the resolution.

  1. Display the GOES-7 Full Disk image in its original resolution (16 km) on frame 1. Center the image on earth coordinates 0° and 112°.

    Type: IMGDISP BLIZZARD/G7-VIS-FD 1 LATLON=0 112

  2. Decrease (blow down) the image resolution of the GOES-7 Full Disk image by a factor of 2 and display it on frame 3.

    Type: IMGDISP BLIZZARD/G7-VIS-FD 3 LATLON=0 112 MAG=-2 SF=YES

  3. Magnify (blow up) the image resolution of the GOES-7 Full Disk image by factor of 2 and display it on frame 2.

    Type: IMGDISP BLIZZARD/G7-VIS-FD 2 LATLON=0 112 MAG=2 SF=YES

  4. Loop the frames.

    Press: Alt L

  5. Change the loop sequence to view the images in the order of increasing resolution.

    Type: LS 3 1 2

  6. Show frame 1 and list the data and brightness values inside the cursor.

    Type: PC C;SF 1;IMGPROBE LIST BOX BRIT MODE=N

    Notice you have 5 lines and 5 elements of data.

  7. Show frame 3 and list the data and brightness values inside the cursor.

    Type: SF 3;IMGPROBE LIST BOX BRIT MODE=N

    Notice that you have 10 lines and 10 elements of data. Because the image was blown down by a factor of 2, every second line and element was sampled. Therefore, the number of lines and elements read from the area is twice the amount displayed as an image. The following equation determines the number of lines and elements in the cursor area for a blow down:

    cursor size*blow down factor

    which for this example is 5 * 2 = 10.

  8. Show frame 2 and list the data and brightness values inside the cursor.

    Type: SF 2;IMGPROBE LIST BOX BRIT MODE=N

    There are 3 lines by 3 elements of data listed. The following equation determines the number of lines and elements in the cursor area for a blow up:

    (cursor size-1)/blow up factor + 1

    which for this example is [(5 - 1)/2] + 1 = 3.

 


Previous: Satellite Imagery - Listing Image Data Next: Satellite Imagery - Copying and Displaying Images Table of contents Index Glossary Images Frames ITC-NGIC McIDAS-X Training Workshop > Imagery Display and Analysis > Satellite Imagery